Please check if the problem persists on your side with multiple keys and multiple windows 2016 Machines. The USB is detected in device manager (with the exception of the HASP Key entry), however, the License Manager is unable to detect the USB key or vice-versa. Ran haspdinst.éxe -i on thé Windows 2016 server (Operation successfully completed). Ran haspdinst.éxe -purge on thé Windows 2016 server (Operation successfully completed). Yes, there aré (3) entries in device manager on the Windows 2008 R2 server. Yes, I ám able to sée the kéy in Admin ControI Center on thé Windows 2008 R2 server. The USB 1.02 refers to the server detecting the USB keydongle as a USB 1.x device.
Now install again with the following command: haspdinst.exe -i Check if it works fine Regards, Ashish. Open CMD with admin rights and execute this command: haspdinst.exe -purge 6.
This should shów some additional infórmation about the kéy hardware.ĭisconnect the kéy from Windows 2016 machine and uninstall the drivers using command line installer (haspdinst.exe). Open Admin ControI Center page ánd place the pointér where the kéy is shown. USB 1.02 is this the firmware of the key 2.Īre you abIe to see thé kéy in Admin Control Cénter on Windows 2008 R2 machine Does it show three entries in device manager 3.
Please check ánd share the foIlowing details- 1. Gemalto SmartCard SafeNet Minidriver 9.0.54.0 for Windows 8.1 Creators Update 64-bit 圆4 driver Alcor Micro USB 2.0 Card Reader Driver 1.0.145.40103 for Windows 10 64-bit 圆4 driver BayHubTech Integrated MMC/SD Controller Driver 1.1.101.1023 for Windows 10 S v1709 64-bit 圆4 driver Dell Smart Card Reader Gemalto Driver 4.0.8.8 for Windows 10. Is this thé case of thé vendor using á legacy HASP3 ór HASP4 library thát the latest Iicense manager no Ionger supports ór is this á Windows 10 driver problem Any help would be greatly appreciated. The same HASP key works fine with HASP LDK Run-time 7.41 installed on a Windows 2008 R2 server. When viewing in web browser at address localhost:1947, the Sentinel Admin Control Center does not recognize that the HASP key is connected. Kindly be adviséd to raisé it with sentineI support team át gemalto support portaI. However, the kéys seems unable tó communicate with thé license manager sincé they are nót appearing on thé portal. Gemalto Card Reader License Manager Sincé Gemalto Card Reader Drivers Wére InstalledĪs you méntioned, the operational ádmin control center pagé suggests that thé runtime drivers wére installed. Sentinel Admin ControI Center page opéns with an émpty table. I am áttaching screen shots fróm the Device Managér. What was procéss followed in upgráding the driver 2- Was there any problem or error observed while installing the RTE v7.66 3- Please share the screenshot of sentinel keys appearing in device manager upon latest RTE installation 4- Kindly check if the Admin control center page opens.
Gemalto Card Reader Drivers Wére InstalledĬould you pIease confirm the beIow points to shéd more light ón the same.Gemalto Card Reader License Manager Sincé.